Heat Pump vs Electric Heat PTAC: Which One Do You Need

Home » Knowledge Base » Heat Pump vs Electric Heat PTAC: Which One Do You Need

The difference between a heat pump and an electric heat PTAC is how each one makes heat. A heat pump PTAC moves heat in from outdoors and uses far less electricity, while an electric heat PTAC warms the room with a heating element.

TL;DR

  • Both types cool the same way. A Genuine Comfort Elite 12,000 BTU heat pump and electric heat PTAC share the same cooling output and the same EER of 11.6.
  • A heat pump PTAC has two ways to heat. It heats with the heat pump down to 23°F (–5°C) outdoors, then switches to the same electric heater an electric heat model uses.
  • Heat pumps use much less power to heat. The U.S. Department of Energy says a heat pump can cut electricity use for heating by about 65% compared with electric resistance heat.
  • The price gap is small. As of November 2026, a Genuine Comfort Elite heat pump costs about $18 to $23 more than the electric heat model of the same size and amperage.
  • Electric heat still fits some rooms. It suits warm climates where the heat rarely runs, and buyers who want the lowest upfront price.

The Short Answer

For most buildings, a heat pump PTAC is the better buy. It cools exactly like an electric heat PTAC, heats with far less electricity whenever it is above 23°F outside, and still has an electric heater for colder hours. At Genuine Comfort Elite prices, it costs only about $18 to $23 more per unit.

An electric heat PTAC makes sense where heating is rare, such as rooms in warm southern climates that need heat only a few days a year. It also suits buyers for whom the lowest purchase price matters most. Both types fit the same 42″ x 16″ wall sleeve and carry the same 6-year parts warranty, so either one can replace the other.

How Each Type Heats a Room

Electric heat PTAC

An electric heat PTAC (packaged terminal air conditioner) uses its compressor only for cooling. To heat, it runs electricity through a heating element, much like a space heater or baseboard heater. This is called electric resistance heat. Every unit of electricity becomes one unit of heat, no more.

Genuine Comfort Elite electric heat models come with a 2.5 kW, 3.5 kW or 5 kW heater. The heater size depends on the cord and circuit: 15, 20 or 30 amps.

Heat pump PTAC

A heat pump PTAC runs its refrigerant cycle in reverse to heat. Instead of pushing heat out of the room, it pulls heat from the outdoor air and moves it inside. The U.S. Department of Energy notes that heat pumps transfer rather than generate heat, which is why they need less electricity.

Outdoor air holds less heat as it gets colder. So a heat pump PTAC also carries an electric heater, the same sizes as the electric heat models. Genuine Comfort Elite heat pumps heat with the heat pump down to 23°F (–5°C) outdoors, then the electric heater takes over.

How electric heat and heat pump PTACs heat
Electric heat PTACHeat pump PTAC
CoolingCompressorCompressor (same as electric heat)
Heating above 23°F outdoorsElectric heaterHeat pump
Heating below 23°F outdoorsElectric heaterElectric heater
Electricity used for heatingHigherMuch lower while the heat pump runs
Upfront priceLowerSlightly higher

Heat Pump vs Electric Heat PTAC: Specs Side by Side

The table compares the two most popular Genuine Comfort Elite 12,000 BTU models, both 208/230V and 20 amps. Apart from the heating method, they are nearly identical.

Source: Genuine Comfort 2026 Elite Series spec sheet
Elite 12,000 BTU, 208/230V, 20AElectric heat (GC42P-E12KC3-3)Heat pump (GC42E-H12KC3-3)
Cooling output11,800 / 12,000 BTU (208V / 230V)11,800 / 12,000 BTU (208V / 230V)
Cooling efficiencyEER 11.6EER 11.6
Heat pump heating outputNone10,500 / 10,800 BTU (208V / 230V)
Electric heater3.5 kW, 8,900 / 10,900 BTU3.5 kW, 8,900 / 10,900 BTU
Heat pump runs down toNot applicable23°F (–5°C) outdoors
Room freeze protectionYes, at 32°FYes, at 32°F
Wall sleeve42″ x 16″42″ x 16″
Parts warranty6 years (Genuine Care)6 years (Genuine Care)

Notice the heating rows. At 208V, the 12,000 BTU heat pump delivers 10,500 BTU from the heat pump alone, more than the 8,900 BTU its 3.5 kW heater gives at the same voltage. In other words, in mild cold it heats the room faster and for less power.

Genuine Comfort Elite Series 12,000 BTU heat pump PTAC, front view with the control panel cover open
Shown: Genuine Comfort Elite Series 12,000 BTU heat pump PTAC, 208/230V, 20 amp.

Heating output by size

Here is the heat each Elite size delivers from the heat pump and from the electric heater, at 208V / 230V:

Genuine Comfort 2026 Elite Series, 208/230V models. Electric heat and heat pump models use the same heater sizes.
Elite sizeHeat pump heatingHeater 2.5 kW (15A)Heater 3.5 kW (20A)Heater 5 kW (30A)
7,000 BTU6,200 / 6,300 BTU6,300 / 7,800 BTU8,900 / 10,900 BTUNot offered
9,000 BTU7,500 / 7,800 BTU6,300 / 7,800 BTU8,900 / 10,900 BTUNot offered
12,000 BTU10,500 / 10,800 BTUNot offered8,900 / 10,900 BTU12,200 / 15,000 BTU
15,000 BTU13,200 / 13,500 BTUNot offered8,900 / 10,900 BTU12,200 / 15,000 BTU

Purchase Price and Running Cost

Purchase price

On Genuine Comfort Elite units, the heat pump premium is small. These are the prices on PTAC4Less as of November 2026, for 208/230V units at 20 amps:

Prices change; check the product page for the current price.
Elite sizeElectric heatHeat pumpDifference
7,000 BTU$673.32$696.12$22.80
9,000 BTU$691.57$712.09$20.52
12,000 BTU$709.80$728.08$18.28
15,000 BTU$755.45$773.68$18.23

Running cost

The bigger difference shows up on the power bill. According to the U.S. Department of Energy, a heat pump can reduce electricity use for heating by about 65% compared with electric resistance heating such as baseboard heaters.

A PTAC only earns that saving during the hours its heat pump is running, which means hours above 23°F outdoors on the Elite. Actual savings depend on the local climate, how many hours the room is heated and the local electricity rate, so no single dollar figure fits every building. Still, in most of the country a $20 premium is small next to a winter of lower heating bills.

How Climate Changes the Choice

Climate decides how many hours a heat pump PTAC actually spends using its heat pump. Here is how it plays out:

Matching the PTAC heating type to the climate
ClimateTypical winterBetter choice
Warm (Gulf Coast, Florida, Southern California, Arizona)Heat runs only a few days a yearEither works. Electric heat saves a little upfront.
Mild to moderate (most of the South, Mid-Atlantic, Pacific Northwest)Many heating days above 23°FHeat pump. It covers most heating hours.
Cold (Midwest, Northeast, mountain areas)Long stretches below freezing, some below 23°FHeat pump. It handles fall, spring and milder winter days, and the heater covers the coldest hours.
Very cold, heat running all winterMany days below 23°FHeat pump with the right heater size, or an inverter Low Ambient model

Even in cold regions, a heat pump PTAC is not worse than electric heat. On the coldest days, both types heat with the same electric heater. The heat pump simply adds cheaper heating on every day that stays above 23°F.

For very cold buildings, the Genuine Comfort Ultra Series is another option. Its Low Ambient (-L) inverter models keep the heat pump running down to –22°F. See Inverter PTAC vs Standard PTAC for those specs.

Which One to Buy

Heat pump or electric heat: a quick decision guide
Choose a heat pump PTAC ifChoose an electric heat PTAC if
The room is heated for more than a few weeks a yearHeat is needed only a handful of days a year
Lower heating bills matter to the owner or tenantThe lowest purchase price matters most
The building runs on 265V power (Elite 265V models are heat pump only)The building is 208/230V and in a warm climate
The building wants lower running costs over the life of the unitThe job is a like-for-like swap of electric heat units and the owner is happy with them

One detail matters for 265V buildings. Genuine Comfort Elite 265V models come only as heat pumps (7,000, 9,000, 12,000 and 15,000 BTU), so for example the Elite 12,000 BTU 265V heat pump is the choice there.

Genuine Comfort Elite Series 12,000 BTU electric heat PTAC
The electric heat option: Genuine Comfort Elite Series 12,000 BTU electric heat PTAC, 208/230V, 20 amp.

Replacing an Existing PTAC

Switching heating types is usually simple, because heat pump and electric heat PTACs share the same wall sleeve and plug styles. Before ordering, check these four things:

  • Voltage and amperage. Match the circuit and receptacle: 15, 20 or 30 amp at 208/230V, or 20 amp at 265V. The plug shape differs by amperage.
  • Wall sleeve. Genuine Comfort PTACs fit a standard 42″ x 16″ sleeve. Check that the existing sleeve is that size and in good condition.
  • Wall thermostat. If the room uses a wall thermostat instead of the unit’s own controls, confirm it supports the heating type.
  • Room size. Pick the BTU size from the room, not the old unit alone. The BTU sizing guide covers how.

On a Genuine Comfort model number, the heating type is easy to read: GC42E-H means heat pump and GC42P-E means electric heat. Other brands code it differently, so check the rating label or the brand’s spec sheet.

Browse both types in the Genuine Comfort lineup, or call PTAC4Less at 833-782-2453 with the old unit’s model number for help choosing. Before winter, run through the PTAC winter checklist on any unit, heat pump or electric.

Frequently Asked Questions

What is the difference between a heat pump and an electric heat PTAC?

Both cool the same way. To heat, an electric heat PTAC uses a heating element, while a heat pump PTAC moves heat in from outdoor air and uses much less electricity. A heat pump PTAC also has an electric heater for very cold weather.

Is a heat pump PTAC worth the extra cost?

For most buildings, yes. Genuine Comfort Elite heat pump models cost about $18 to $23 more than the matching electric heat models as of November 2026, and the U.S. Department of Energy says heat pumps can cut heating electricity use by about 65% compared with electric resistance heat.

Does a heat pump PTAC work in cold weather?

Yes. Genuine Comfort Elite heat pump PTACs heat with the heat pump down to 23°F outdoors. Below that, they switch to their built-in electric heater, so the room stays warm on the coldest days.

Does a heat pump PTAC have electric heat backup?

Yes. Heat pump PTACs carry an electric heater, the same 2.5 kW, 3.5 kW or 5 kW sizes found in electric heat models. The heater runs when it is too cold outside for the heat pump.

Can I replace an electric heat PTAC with a heat pump PTAC?

Usually, yes. Both types fit the same 42″ x 16″ wall sleeve and use the same plugs for each amperage. Match the voltage and amperage, and check that any wall thermostat supports a heat pump.

When is an electric heat PTAC the better choice?

An electric heat PTAC fits warm climates where heat runs only a few days a year, or jobs where the lowest purchase price matters most. In those cases the heat pump has little time to pay back its small premium.